You can have liveness without a timeout. Think about it. Say you set a timeout of 1 minute in your application to transfer 500 mb over a 100mbps link. This normally takes 40s and this is that machines sole job, so it fails fast.
One day, an operator is updating some cabling and changes you over to a 10mbps link for a few hours. During this time, every single one of your transfers is going to fail even though if you were to inspect the socket, the socket is still making progress on the transfer.
This is why we put timeouts on the socket, not the application. The socket knows whether or not it is still alive but your application may not.
One day, an operator is updating some cabling and changes you over to a 10mbps link for a few hours. During this time, every single one of your transfers is going to fail even though if you were to inspect the socket, the socket is still making progress on the transfer.
This is why we put timeouts on the socket, not the application. The socket knows whether or not it is still alive but your application may not.